Patch Devices Settings

Update on a device or nox user level the device/user settings. If you want to update a setting on a device level, only the device_id needs to be provided. Any of the settings can be updated separately or together.

You can change the following settings:

• The lower and upper room comfort temperature bounds of end users/devices in degrees celcius.

• The lower and upper bounds for domestic hot water heating in degrees celcius. This will determine the maximum and minimum allowed temperatures we allow it to go. This should be changed carefully as it could lead to the tank temperature going too low and cause legionella growth. Below 40 degrees is not recommended, only during vacations.

• The preferred temperature of end users/devices in degrees celcius. This is also used to determine when to start cooling in temperature_control_mode auto or cooling mode.

• Temperature control mode to determine if you only want heating or cooling or both (auto) or none of both (off). If auto is chosen, our system will decide if cooling is necessary based on outside temperature and upper comfort bounds. Off means we will turn room heating and cooling off and if this is not possible, we will configure the heat pump in a way so it will not cool or heat. If heating is chosen we will only heat and it will be based on the preferred temperature or the schedule and the comfort bounds. If cooling is chosen, we will only cool and it will be based on the preferred temperature or the schedule, outside temperature and the comfort bounds.

• Enable/Disable steering optimizations. Flex_trading is mutually exclussive with the other optimizations. The other optimizations can be enabled together. If flex_trading is enabled, we disable all other optimizations. If any other optimization is enabled, we disable flex_trading.

• The country code and the postal code